Speedi-Bleed™ is an easy to use professional quality brake pressure bleeder tool that allows a single person to bleed or flush a complete brake system in 20-30 minutes. The tool utilizes a small volume of air from a tire ** to pump fresh brake fluid through the brake lines, and remove trapped air and old fluid via the bleeder screws.

** 1-3 psi Tire Pressure Loss Typical

View Speedi-Bleed Instruction Sheet
.

4 FAST & EASY STEPS TO BLEED BRAKES LIKE A PROFESSIONAL .

1. Connect Speedi-Bleed adapter to master cylinder reservoir .

2.Connect the filled Speedi-Bleed fluid bottle to both adapter and tire .

3. Set the Speedi-Bleed pressure regulator to 15-20 psi .

4. Open bleeder screws for 10-15 seconds (or until fluid clean)

• Before using SPEEDI-BLEED for first time, perform a dry run (NO FLUID In BOTTLE) to get familiar with tool and setting working pressure

• Always tighten wing nuts evenly & firmly (C100 & C300 adapters). After removing adapter, an indent pattern should be visible on rubber gasket)

• Always start with 0 psi on gauge and "Slowly" adjust regulator until working pressure is set. Stop at every 5 psi increase and check for leaks.

• Before connecting SPEEDI-BLEED adapter, remove any float or screen from inside the master cylinder reservoir (If required)

• Bleeding m/cyl on vehicle (before wheels) will get a firmer brake pedal. Place rag under m/cyl brake line fitting(s) and crack open for 5-10 seconds.